Skip to content
Shop Our Categories
P60 Drop Ins
TRIPLES - QUADS
P60 + Host
Advance Program Flashlights
Wrapping a P60 Drop In
Lumens vs Real OTF Lumens
Reverse Clicky vs Forward Clicky
LED Tints and Power
Nav Menu 2
Nav Menu 3
Nav Menu 4
Nav Menu 5
Nav Menu 6
Nav Menu 7
Nav Menu 8
Account / Login
TRIPLES - QUADS
S2plus-Nichia Triple Emitter Light Advance Program -Regulated
Nichia 219C D280 80 CRI+ 5000K
XPL HI V3-3B 5200K (10) [Add $10.00]
Nichia 219C D320 70+CRI 5000K
Nichia 219C D240 90+CRI 4000K
Enhanced Forward Clicky (5) [Add $5.00]
Reverse Clicky -Illuminated (6) [Add $6.00]
Reverse Clicky (-4) [Subtract -$4.00]
1x Sanyo/Pana NCR18650GA 3500mah [Add $9.00]
2x Sanyo/Pana NCR18650GA 3500mah [Add $18.00]
1x Samsung 30Q [Add $9.00]
2x Samsung 30Q [Add $18.00]
Xtar MC1 [Add $7.00]
Xtar VC2 Plus [Add $24.00]
Pocket Clip (CV) [Add $3.00]
Nylon Holster (0350) [Add $3.50]
Protected Cell (>67mm)
Unproteced Cell (<67mm)
The S2+ is built with Triple Nichia emitters or XPL HI emitters.
The Nichia emitters have a very low forward voltage allowing it to run at high current. This triple is built using the Advance Program Regulated
driver that will limit the current to 4.9A. This configuration is recommended for the Nichia high CRI emitters because of their lower efficiency.
The Advance Program Regulated driver is also a good choice for the higher output emitters because it allows the driver's thermal regulation
to better manage the heat generated by triple emitters.
With a Nichia 219C high CRI emitters, expect around 1400 lumens and with the higher output emitters (Nichia D320 and XPL HI V3) the output is typically around 1750 lumens.
Although the maximum output from the AP-Regulated driver is lower, it will allow you to use the higher output modes for more than just a few seconds.
The copper MCPCB is soldered onto the specially designed pill.
The driver is potted and has easy change contacts -both a solid contact and a beryllium copper spring are included.
The TIR (triple optic) is protected by a ultra-thin, scratch resistant AR lens.
The switch has a copper bypass and copper contact cap installed.
Click here to read about
'Enhanced Forward Clicky Switch'
*Multi-Emitter lights do not throw as well as single emitter/reflector lights, but they make up for it in raw output.
It requires a single 18650, medium to high current battery (not included, but may be added as an option),
Input voltage: 2.9V-4.5V
Current: Up to - Direct Drive
24 Brightness Steps (1-22 are regulated)
Memory function: off-time ½ second
PWM: 4500+Hz<br/>Reverse Polarity Protection
Low voltage protection: At 2.9-3v, the light will drop to low mode and slowly flash
User Configurable Mode Groups
User Configurable Memory
User Configurable Thermal Control
C8 Triple Emitter - Advance Program
P60 Quad Emitter Drop In - Advance Program
S2plus-Nichia Triple Emitter Light Advance Program -Direct Drive
Share your knowledge of this product.
Be the first to write a review »